Loading ...
Loading ...
Loading ...
®
10"
STEP 5 - ASSEMBLE KNOB
Place the height adjustment strap to the inside of the
height adjustment handle. Place the tooth-lock washer
(I) between the height adjustment strap and the height
adjustment handle. Insert the carriage bolt (D) through
the strap, the tooth-lock washer and the handle.
Assemble the flat washer (H) and the plastic knob (V)
onto the end of the bolt and tighten. See figure 4.
HEIGHT
ADJ.
HANDLE
FLAT WASHER (H)
KNOB (V)
CARRIAGE /
BOLT (D) I
TOOTH LOCK
WASHER (I)
FIGURE 4
STEP 9a - ASSEMBLE HITCH BRACKETS
• If the tractor hitch is less than 10" above the ground,
assemble the hitch brackets as shown in figure 6.
Insert two hex bolts (B) through the brackets, with
the rear hex bolt between the cross bolts in the hitch
tubes. Secure the hex bolts (B) with two nylock nuts
(F). Do not tighten yet. See figure 6.
Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (L). See figure 6.
FIGURE 6
STEP 6 - FASTEN HITCH TUBES TOGETHER
Fasten the hitch tubes together using two hex bolts (A)
and nylock nuts (F). See figure 5. Do not tighten yet,
STEP 7 - ASSEMBLE GRiP
Assemble the grip (U) onto the end of the height
adjustment handle as shown in figure 5.
HEX BOLT (A)
NYLOCK NUT (F)
FIGURE 5
STEP 8 - MEASURE TRACTOR HITCH HEIGHT
• Use the mark along the side of this page to measure
the height of the tractor hitch. The mark is 10" from
the bottom of the page. If the tractor hitch is less than
10" above the ground, go to STEP 9a. If the tractor
hitch is 1O" or more above the ground, go to STEP 9b.
STEP 9b - ASSEMBLE HITCH BRACKETS
= If the tractor hitch is 10" or more above the ground,
assemble the hitch brackets as shown in figure 7.
Insert two hex bolts (B) through the brackets, with
the rear hex bolt between the cross bolts in the hitch
tubes. Secure the hex bolts (B) with two nylock nuts
(F). Do not tighten yet. See figure 7.
Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (L). See figure 7.
HEX BOLTS (B)
HAIRPIN _
COTTER (L)
BENT HITCH
BRACKET /
SPACERS (J )
|
HITCH BRACKET
FIGURE 7
I
I
NYLOCK NUTS (F)
STEP 10 -TIGHTEN BOLTS
Tighten the four bolts assembled in steps 1, 2 and 3.
Tighten the two bolts assembled in step 6.
Tighten the two bolts assembled in step 9a or 9b.
Loading ...
Loading ...
Loading ...