Loading ...
Loading ...
Loading ...
TOREMOVECABLES,REVERSE
ORDER-
° RemoveBLACKcablefirstfrom chassis
and then from the fully charged battery°
Remove RED cable last from both bat-
teries.
Positive Terminal Negative Terminal
Hood
Headlight
Wire
Connector
Positive Terminal
.3harged
Battery
Negative Terminal
TO REPLACE HEADLIGHT BULB
o Raise hood.
o Pull bulb holder out of the hole in the
backside of the grill
o Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill
° Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
o Check widng. See electrical wiring dia=
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive..type
plug-in fuse° The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
o Raise hood.
o Unsnap headlight wire connector.
o Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
o To replace, reverse above procedure&
ENGHNE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary_ Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
° With engine not running, move throttle
control lever from slow to choke posi-
tion_ Slowly move lever from choke to
fast position_
o Check to see if hole in throttle lever and
hole in speed control bracket are
aligned_
o If holes are not aligned, loosen cable
clamp screw and align the holes by
inserting a pencil or a 1/4" drill bit
through both holes.
o Pull throttle cable up to remove slack
and tighten cable clamp screw. Remove
alignment pencil or drill bit.
TO ADJUST CARBURETOR
The carburetor has been preset at the fac-
tory and adjustment should not be neces-
sary. However, minor adjustment may be
required to compensate for differences in
fuel, temperature, altitude or load. If the
carburetor does need adjustment, proceed
as follows:
In general, turning the adjusting needles
in (clockwise) decreases the supply of fuel
to the engine giving a leaner fuel/air mix-
26
Loading ...
Loading ...
Loading ...