Loading ...
Loading ...
Loading ...
I:I_-.LI IN_5 IALLAI IUN -
o Install new belt in reverse order of
removal
Mandrel
Pulley
o MaKe sure Delt IS rn all pulley grooves
and inside all belt guides.
o Install mower in reverse order of
removal irrstructions.
Idler
Pulleys
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle_
If tractor requires more than six (6) feet
stopping distance at high speed in high-
est gear, then brake must be adjusted..
o Depress clutch/brake pedal and engage
parking brake.
Measure distance between brake oper-
ating arm and nut "A" on brake rod..
o If distance is other than 1-3/4", loosen
jam nut and turn nut "A" until distance
becomes 1-3/4'L Retighten jam nut
against nut "A".
o Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distartce is still
greater than six (6) feet in highest gear,
further maintenance is necessary°
Contact your nearest authorized ser-
vice center/department.
3erating
Arm
_J
Do Not touch this nut, Iffurther brake adjustment is
necessary contact your nearest authorized service
center/department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface= Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footresL
, o Remove mower (See "TO REMOVE
MOWER" in this section of this manual,)
o Remove upper belt keeper.
o Remove belt from stationary idler and
clutching idler:
o Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over' cool-
ing fan blades.
o Pull belt toward front of tractor and
remove downward from around engine
pulley_
o Install new belt by reversing above pro-
cedure.
IMPORTANT: Make sure upper belt keep-
er is positioned properly between Iocator
tab.
Engine ---------
Pulley
Clutching Idler-
Stationary Idler-
Transrnission
Input Pulley
Keeper
24
Loading ...
Loading ...
Loading ...