Loading ...
Loading ...
Loading ...
SECTBON 6 CARE OF YOUR SOFTENER
!
e TRANSFORMER UNPLUGGED AT THE WALL
OUTLET, POWER CABLE LEADS LOOSE, FUSE
BLOWN, CIRCUIT BREAKER POPPED, OR CIR-
CUIT SWITCHED OFF m Check for loss of power
due to any of these and correct,. With the power back
on, look at the time display and read PROGRAM
MEMORY, page 18.
!
® MANUAL BYPASS VALVE IN BYPASS POSI-
TION _ Look at FIG.. 10 on page 12o Move the
bypass valve stem to SERVICE (pull OUTWARD),.
e DIRTY, PLUGGED OR DAMAGED NOZZLE &
VENTURi _ Take apart and clean or replace dam-
aged parts (page 23)..
® VALVE DRAIN HOSE PLUGGED _ The drain
hose must not have kinks, sharp bends, or be raised
too high above the softener (See page 11)_
WATER HARD SOMETIMES
® HARDNESS NUMBER SETTING TOO LOW-
Press and release the SELECT button until HARD-
NESS shows in the display° Read the hardness num-
ber in the display and be sure the same grains per
gallon number is shown on your water analysis re-
port_ See page !6 to reset° Press and release the
SELECT button until the present time shows in the
disptay_
® USING HOT WATER WHEN THE SOFTENER IS
REGENERATING _ Avoid using hot water during
this time because the water heater refills with hard
water (See Automatic Bypass, page 20)_
® INCREASE IN THE GRAINS OF HARDNESS IN
YOUR WATER SUPPLY _ Ask your Sears retail or
catalog store for a new water analysis. Then make a
new hardness number setting (page 16)..
25
HARDNESS
Loading ...
Loading ...
Loading ...