Loading ...
Loading ...
Loading ...
iNSTALL
!
1 4, CHECK LIST OF STEP BY STEP GUIDES
To be sure you have done all the steps to
install the softener, read the following list:
tt Is the house water flow going INTO the softener
valve INLET? Trace piping to be sure. (step 7 and
FIG_ 2)
_" Is the plumbing bypass valve set for SERVICE?
(step 10)
Is the valve drain hose connected the right way,
and without sharp bends or kinks that could stop
or reduce water flow? (step 8)
Is the softener power cable connected to the
transformer...and is the transformer' plugged into
an inside, 120V-60Hz electrical outlet? (steps 12
and 13)
_" Be sure to restart the water heater. ....step t5_
WATER
1 5. TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT.
NOTE: Your WATER HEATER is filled with hard
water. To have fully soft water right away,
you candrain the water heaterso itrefills with
soft water, If you don't drain it, it will take a
few days before you have fully soft water.
To drain the water heater, open a hot water faucet
and let it run until the water turns cold. Then close the
faucet.
GO TO SECTION 4, "SOFTENER START-UP."
14
Loading ...
Loading ...
Loading ...