Loading ...
Loading ...
Loading ...
NEVER set the Acetylene Regulator (Parts 1-19) to a delivery pressure above 15 PSI.
See gures I, J and K
FIGURE I
FIGURE J
WELDING TIP CHART
OXYACETYLENE MULTI-FLAME HEATING CHART
OXYACETYLENE CUTTING NOZZLE CHART
FIGURE K
9. To determine the proper acetylene regulator parts (parts 1-19) pressure and oxygen regulator (parts
A1-A20E) pressure for neutral ame adjusting. Refer to Figures I and K
10. Depending on use, attach either the cutting nozzle (D6) or welding nozzle (D3) to the cutting attachment
(parts C1-C27) See gure L
11. Open the oxygen control valve (B8 with Ox label B9) on the torch handle. Open the pre-heat oxygen
valve (C26) on the cutting attachment. Adjust the oxygen regulator parts (A1 - A20) to the desired working
pressure. Then close the oxygen control valve on the torch handle. See gure L
7
CHARTS
Loading ...
Loading ...
Loading ...