Loading ...
Loading ...
Loading ...
7
GENERAL ASSEMBLY INSTRUCTIONS
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Position the hose storage rack as illustrated. Squeeze the open sides of the hose storage
rack inward. Insert the hose storage rack into the channel on the front side of the power head
just above the top edge of the tank. Verify that the rack is secured in place as shown in Fig.
8. Then squeeze in the other hose storage rack and insert it into the corresponding channel
making sure it is secured (Fig. 6 - 9).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge lter is not installed, refer
to page 12 for installation instructions (Fig. 10 & 11).
8. For wet vacuum cleaning, remove the cartridge lter, and install the supplied foam wet lter.
See page 12 for installation instructions (Fig. 12).
9. Place the power head back on the collection tank, and secure into place using the latches
(Fig. 13 & 14).
10. Insert the locking end of the hose into the vacuum port of the collection tank and turn
clockwise to lock into place (Fig. 15).
11.
Choose the desired accessory and insert onto the end of the hose or extension wand (Fig. 16).
A Philips head screw driver is required.
1 2 3 4 5
11 12
16151413
6
7
8
9
10
WARNING:
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO
REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
Loading ...
Loading ...
Loading ...