Loading ...
Loading ...
Loading ...
10
BLOWER OPERATION
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature follow the instructions listed.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port. Remove noise diffuser from blower port.
4. Insert the larger end of the hose into the blower port on the back side of the power head and
lock into position (Fig. 2).
5. Fit the desired extension wand and/or nozzle to the free end of the vacuum hose (Fig. 3).
6. Verify that the on/off switch is in the ‘O’ OFF position before plugging the power cord into the
outlet (Fig. 4 & 5).
7. Before turning ON the vacuum, rmly hold the loose end of the hose. Turn the motor on by
pressing the switch to the ‘I’ ON position (Fig. 6).
8. Once you have completed blowing, ip the on/off switch to the 'O' (OFF) position and unplug
the power cord from the outlet (Fig. 7).
1
7
2 3 4 5 6
6. Once you have completed vacuuming, ip the on/off switch to the 'O' (OFF) position and
unplug the power cord from the outlet.
7. After use, empty the collection tank by unscrewing the drain cap. Drain liquids into a suitable
receptacle or drain (Fig. 6). Remember to ret the drain cap to the collection tank. Remove the
foam wet lter and allow it to air dry before storage.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
in the liquid; leave a gap at the tip of the nozzle opening to allow air inow. The machine is tted
with a oat valve that stops the suction action when the collection tank reaches its maximum
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and empty the liquid into a suitable receptacle or drain. To continue
vacuuming, ret the collection tank with the drain cap. After wet vacuuming, turn the machine
off and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage.
REMEMBER! The foam wet lter must be removed after wet vacuuming and a cartridge lter must
be installed before dry vacuuming again.
WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
Loading ...
Loading ...
Loading ...