Kenmore 79079919302 Use & Care Guide

Loading ...

General Care & Cleaning

FEATURE OVERVIEW

Removing & Replacing Warmer Drawer

Pullup withfinger

To Remove and Replace Warmer (Warm & Ready TM) Drawer

Left Gfide

To Remove Warmer Drawer:

1. _ Turn power off before removing the Warmer Drawer.

2. Open the drawer to the fully opened position.

3. Locate glide lever on each side of drawer, pull up on the left glide lever and

push down on the right glide lever.

4. Pull the Warmer Drawer away from the range.

To Replace Warmer Drawer:

Push down with finger

Fig. 1

Pull the bearing glides to the front of the chassis glide (See Fig. 2).

Align the glide on each side of the drawer with the glide slots on the range.

Push the Warmer Drawer into the range until levers "click"

(approximately 2"). Pull the drawer open again to seat bearing glides into

position. If you do not hear the levers "click" or the bearing glides

do not feel seated remove the drawer and repeat steps 1-3. This wilt

minimize possible damage to the bearing glides.

Fig, 2

Oven Lights

FEATURE OVERVIEW

Operating Oven Lights

Replacing Oven Light

_Vire

Holder

Fig. 3

Electrical Shock Hazard can occur and result

in serious injuryor death. Disconnect appliance from electric

power before cleaning and servicing the warmer drawer.

Be sure the range is unplugged and all parts are

COOL before replacing oven light(s). Wear a leather-faced glove for

protection against possible broken glass.

To Operate the Oven Lights

Both of the interior oven lights automatically turn on when the oven

door is opened. Press _ to turn the lights ON and OFF when the

oven door is closed. Each oven light is located at the rear wall of the

oven interior and is covered with a glass shield held by a wire holder

(See Fig. 3). The Glass Shields must be in place whenever the oven

is in use.

To Replace the Oven Light(s):

1. Turn electrical power off at the main source and unplug the

range.

2. Press wire holder to one side to release the glass shield.

3. Replace the old bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug in the

range).

6. The clock wilt then need to be reset. To reset, see Setting the

Clock in this Use & Care Guide.

Loading ...

Kenmore 79079919302 Dual Fuel Range

Use & Care Guide - Page 35