Loading ...
Loading ...
Loading ...
USB Export / Import
16
The Oven controller is equipped with USB connectivity, through the USB port located on the lower right hand side of the control panel.
The set of programs, P01 - P30, stored in the controller mem ory can be:
Written to a USB memory stick (Export).
Replaced with a set of programs located on the USB stick (Import).
1. To export the set of programs from the controller to the USB stick:
Ensure the oven is in ‘Standby Mode’ – ‘On / Off’ LED is lit.
Insert a USB memory stick into the USB port.
Upper display will show ‘USB’ and lower display will show ‘EPr’ (Export Programs).
Press ‘Start / Stop’ button.
Lower display will alternate between ‘rEv’ and ‘001’ (Revision Number e.g. 000 to 999).
(The set of programs can be given a different/new revision number at this point)
Rotate ‘Timer’ Knob to select revision number required.
Press ‘Start / Stop’ button to copy programs from controller to USB stick.
If an error message (Err, Er1 or Er2) appears in lower display, refer to
section ‘Fault Finding’
Lower display will show ‘rUn’, followed by ‘dnE’ once copying is done.
Remove USB memory stick from USB port.
Controller will go back to ‘Standby Mode’.
The export feature is useful for backing up the set of programs created in the controller,
creating a copy of the set of programs to apply to another oven, and for editing programs
externally.
2. To import the set of programs to the controller from the USB stick:
Ensure the oven is in ‘Standby Mode’ - ‘On / Off’ LED is lit.
Insert a USB memory stick, containing at least one ‘MPRGRXXX.csv’ file into the USB port
(See Section ‘Import / Export Files’).
Upper display will show ‘USB’ and lower display will show ‘EPr’ (Export Programs).
Rotate ‘Timer’ knob to change to ‘IPr’ on lower display (Import Programs).
NOTE: IPr will not show on display if a ‘MPRGRXXX.csv’ file is not present.
Press ‘Start / Stop’ button to copy programs from USB stick to controller.
If more than one file is present, i.e. MPRGR001, MPRGR002…, the option to select between
these will appear:
Lower display will alternate between ‘rEv’ and ‘001’ (Revision Number e.g. 000 to 999).
Rotate ‘Timer’ Knob to select revision number required.
(A maximum of 10 revisions on the USB Stick will be selectable).
Lower display will show ‘rUn’, followed by ‘dnE’ once copying is done.
Remove USB memory stick from USB port
Controller will go back to ‘Standby Mode’.
The import feature is useful for restoring a backed up set of programs, copying programs from another oven, and for loading
programs edited externally.
‘ON / OFF’ LED is ‘On’
when oven is in
‘Stand-By’ Mode.
‘Timer-Start / Stop’ LED
is ‘On’ when oven is in
’Stand-By’ Mode.
Loading ...
Loading ...
Loading ...