Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
• Remove the exterior and interior packaging.
• IMPORTANT: Before connecting this Beverage cooler to a power source, let it
stand upright for approximately 24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
To Install Stainless Steel Handle
Illustration #1 Illustration #2
1) Pull away the door gasket in the area where the handle is to be installed, as
Illustration #1. The gasket is easily removed by hand, no tools are necessary.
2) Align the handle with the pre-installed screws on the door frame. Tighten the
screws with a screwdriver until the handles secure tightly against the door frame, as
Illustration #2. (Do NOT over tighten as this will cause damage to the handle
assembly).
3) Replace the door gasket to its original position.
1
2
3
4
Gasket
Screw
Screw Driver
Handle
07
It is important for the appliance to be leveled in order to work properly. You
may need to adjust the feet to make it level.
•
Storage
10
Removing Shelf
●To avoid the damage of door sealing, please open the door fully when you slide
●If you need to take off the shelf from cabinet, you can pull out the shelf to the
up and out. (See figure below)
position where the notch of shelf is exactly under the plastic post and then lift it
is designed with shelf holder to prevent the shelf pull over and fall off the cabinet.
●For your convenience of taking wine, you can pull out the shelf by 1/3. Our product
out the shelves.
Beverage Cooler Zone
●Shelf one to two - 18 standard 12oz cans per shelf
●Shelf Three - 9 standard 12oz cans per shelf
●Bottom Section - 12 standard 12oz cans Wine Cooler Zone
●Bottom Section - 3 standard 750ml bottles
●Shelf One to Five - 3 standard 750ml bottles per shelf
Loading ...
Loading ...
Loading ...