Loading ...
Loading ...
Loading ...
IMPORTANT SAFETY INSTRUCTIONS
DANGER
Your safety and the safety of others are very important.
This Beverage cooler complies with the applicable safety requirements and is safe for
daily use. However, basic safety precautions should always be followed when using
an electrical appliance, to reduce the risk of fire, electric shock, and personal injury.
• Plug into its own individual electrical outlet with a voltage rating that matches the
rating label on the cooler (115/120V AC only, 60Hz, 10A). Use receptacles that
cannot be turned off by a switch or pull chain. Be sure that the plug is fully inserted
into the receptacle.
• Plug into a grounded 3-prong outlet. Do not under any circumstances cut or
remove the third ground prong from the power cord supplied.
• To protect against electric shock, do not immerse the Beverage cooler, plug or cord
in water or other liquids.
• Never unplug the cooler by pulling the power cord. To disconnect the Beverage
cooler, always grip the plug firmly and pull straight out from the wall outlet.
• Repair or replace immediately all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along
its length or at either end.
• Do not connect or disconnect the electric plug when your hands are wet. Do not
operate the cooler with wet hands, while standing on a wet surface or while standing
in water.
• Unplug the Beverage cooler or disconnect power before cleaning or servicing.
Failure to do so can result in electric shock or death.
• When moving the Beverage cooler, be careful not to roll over or damage the power
cord.
• Never clean Beverage cooler parts with flammable fluids. These fumes can create a
fire hazard or explosion. And do not store or use gasoline or other flammable vapor
and liquids in the vicinity of this or any other appliance. The fumes can create a fire
hazard or explosion.
• Do not attempt to repair or replace any part of your Beverage cooler unless it is
specifically recommended in this manual. All other servicing should be referred to a
qualified technician.
• An empty Beverage cooler can be dangerous to children. Remove any latches, lids,
locks, and/or doors from unused or discarded Beverage coolers to prevent child
entrapment and suffocation. Never allow children to operate, play with or crawl
inside this Beverage cooler.
04
External environment
may require a higher
setting.
Set a colder setting. Allow
several hours for the
temperature to stabilize.
The Beverage cooler has
recently been
disconnected for a period
of time.
It takes 3-4 hours for the
Beverage cooler to cool
down completely.
Prolonged or frequent
door openings.
Open the door less often.
The door is not closed
completely.
Close the door properly.
The door gasket does not
seal properly.
Check the door gasket.
Clean or change gasket if
necessary.
The room temperature is
hotter than normal.
It’s normal for the Beverage
cooler to work harder under
these conditions.
Prolonged or frequent
door openings.
The temperature has not
been set correctly.
The door is not closed
completely.
Close the door properly.
The door gasket does not
seal properly.
Check the door gasket.
Clean or change gasket if
necessary.
Less to open the door.
A large amount of
items has been added
to the cooler.
A large amount of items can
Press either or to
check the set temperature,
and set the temperature
properly.
The Beverage
cooler is not
cold enough.
The
compressor
turns on and
off frequently.
13
reached.
desired temperature is
cause this condition until the
Loading ...
Loading ...
Loading ...