Vevor M1Q-DU03-110 7.2amp Jig Saw 800w, 4-Stage Orbital 0-45° Bevel Curved Cutting, 6 Variable-speed Jigsaw with Laser Scale Ruler

USER MANUAL - Page 13

For M1Q-DU03-110.

PDF File Manual, 16 pages, Read Online | Download pdf file

M1Q-DU03-110 photo
Loading ...
Loading ...
Loading ...
12
Let the jigsaw do the work. Do not press too
hard on the jigsaw.
PARALLEL SAW GUIDE(FIG.7)
If you want to make a saw cut that runs parallel to the edge of the plank, use
the parallel saw guide supplied. You do this as follows:
1. Loosen the screws on the front of bottom plate.
2. Slide the parallel saw guide through the openings at the side of the bottom
plate. Determine the distance between the saw cut and the side of the
workpiece.
3. Secure the guide at this distance with the socket head screws.
4. If the required distance between saw cut and side is
2", set the indicator'5'on the guide exactly above the
saw blade. Tighten the screws again.
CUTTING IN(FIG.8)
If the starting position of the workpiece is not on the
side, or if no hole has been drilled, you must cut into
the surface. To do this, proceed as follows:
1. Put the jigsaw on the rounded edge of the bottom
plate.
2. Switch on the appliance and slowly lower the jigsaw until it touches the
workpiece.
3. Let the jigsaw cut into the workpiece gently without forcing it.
4. When you are through the workpiece, take the jigsaw out of the hole.
5. Place the appliance in the normal position into the surface and continue the
sawing.
You can also cut in by first drilling a
hole into the workpiece. To do this,
use a bit that makes a hole big enough
for the saw blade.
Now you can carry out the steps
described under 'Cutting'.
MAINTENANCE
WARNING!
During maintenance and cleaning always remove the mains plug from the
socket. Never use liquids when cleaning electrical parts of the jigsaw.
Maintain the jigsaw regularly to prevent unnecessary problems. This will
ensure that your appliance remains in optimum condition:
Loading ...
Loading ...
Loading ...