Loading ...
Loading ...
Loading ...
10
ASSEMBLY
EJECTING THE SAW BLADE
To eject the saw blade pull the lever upwards and at the same time remove the
saw blade out of the machine.
ADJUSTING THE BASE PLATE(FIG.2)
ADJUSTING THE ANGLE OF THE BOTTOM PLATE(11)AS FOLLOWS:
WARNING!
Before assembling the saw blade check that the mains plug has been
removed from the socket.
A. Loosen the quick chuck knob (6).
B. Pull the bottom plate(11) back slightly to unlock it.
C. Turn the bottom plate(11) to the right or left in the desired sawing angle.
You can read this on the Protractor (16). The maximum sawing angle is 45° .
D. Push the bottom plate(11)forward again to interlock it.
E. Tighten the quick chuck knob (6).
OPERATION
TURNING THE JIGSAW ON(FIG.3)
1.Press the switch in to put the jigsaw into
operation.The switch can be interlocked with the
interlocking knob.This is done as follows:
A. Press the switch in.
B. Keep the switch (A)pressed in and press he
interlocking knob (B) in. The jigsaw will now
continue to run.
2. Release the interlocking by pressing the switch in again.
Loading ...
Loading ...
Loading ...