Loading ...
Loading ...
Loading ...
9
1. Drilling masonry and concrete
Select the drill/hammer action selector
switch to the “hammer symbol” position.
Tungsten carbide drill bits should always be
used for drilling masonry, concrete etc with
a high speed
.
2. Drilling steel
Select the drill/hammer action selector
switch to the “drill symbol” position. HSS
drill bits should always be used for drilling
steel with a lower speed.
3. Pilot holes
When drilling a large hole in tough material
(i.e. steel), we recommend drilling a small
SLORWKROH¿UVWEHIRUHXVLQJDODUJHGULOOELW
4. Drilling tiles
Select the drill/hammer action selector
switch to the “drill symbol” position to drill
the tile. When tile has been penetrated,
switch over to “hammer symbol” position.
5. Cool the motor
If your power tool becomes too hot, set the
speed to maximum and run no load for 2-3
minutes to cool the motor.
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
RUVLPLODUO\TXDOL¿HGSHUVRQVLQRUGHUWRDYRLGD
hazard.
1. If your drill will not operate, check the power
at the mains plug.
2. If the drill is not drilling properly, check the
drill bit for sharpness, replace drill bit if
worn. Check that the drill is set to forward
rotation for normal use.
,IDIDXOWFDQQRWEHUHFWL¿HGUHWXUQWKHGULOO
to an authorized dealer for repair.
Working hints for your
drill
Maintenance
Troubleshooting
Loading ...
Loading ...
Loading ...