Loading ...
Loading ...
Loading ...
7
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling in
brick, concrete and stone as well as for drilling
in wood, metal and plastic. Machines with
electronic control and right/left rotation are also
suitable for thread-cutting.
1. AUXILIARY HANDLE (See Fig A)
Slide the handle onto the drill and rotate to the
desired working position. To clamp the Auxiliary
Handle, rotate the handgrip clockwise. To
loosen the Auxiliary Handle, rotate the handgrip
counterclockwise. Always use the Auxiliary Handle.
2. INSTALLING THE DEPTH GAUGE (See Fig B)
The Depth Gauge (2) can be used to set a
constant drilling depth. To use the Depth
Gauge, rotate the locking screw on the Depth
Gauge (3) counter-clockwise. Insert the Depth
Gauge through the hole on the Auxiliary Handle.
Slide the Depth Gauge to required depth and
tighten the locking screw for depth gauge (3) by
turning it clockwise.
3. INSERTING A TOOL INTO CHUCK (See
Fig C)
When mounting the drill bit, insert the bit into
the Chuck Jaws as far as it will go. Ensure the
drill bit is in the center of the Chuck Jaws. Using
the Chuck Key provided, insert the key into each
of the three key holes on the chuck and rotate to
tighten. Note: this should be completed for each
hole. Your drill bit is now locked in the chuck.
The bit can be removed by reversing the above
procedure.
4. ON/OFF SWITCH (See Fig D)
Depress to start and release to stop your tool.
Operation instrutions
A
B
C
D
Loading ...
Loading ...
Loading ...