Loading ...
Loading ...
Loading ...
Function introduction
EN
Copyright©Qingdao Hantek Electronics Co.,LTD HT360 series user manual
23
5 Function introduction
5.1 Measuring interface
After the instrument is started, it will enter the measurement interface. If it is in any
other interface, just press to enter the measurement interface;
Each time the material is switched, the hardness scale is changed to Leeb, so the
material should be set first and then the hardness scale;
Under normal conditions, the current measured value cannot be stored when the set
number of impacts is not reached;
The measurement interface mainly displays the measuring impact device, measuring
material, current measured value, measuring times and average value. When the
measurement times reach the set number, the average value changes from white to
green. The display page is as follows:
Figure 5 Measurement Interface
1 Impact device
The instrument supports 5 types of impact devices, namely D, DC, DL, D+15 and G,
which are automatically identified during replacement, and no calibration is required.
2 Measuring direction
It supports vertical downward, oblique downward, horizontal, oblique upward and
vertical upward.
3 Measuring average
4 Measuring materials
The measured materials include steel and cast steel, alloy tool steel, stainless steel,
gray cast iron, ductile iron, cast aluminum alloy, copper zinc alloy (brass), copper tin
alloy (bronze), pure copper and forged steel.
5 Hardness scale
Loading ...
Loading ...
Loading ...