Loading ...
Loading ...
Loading ...
132 IN CASE OF EMERGENCY
Rear Tail, Stop, Backup, Turn Signal And
Rear Side Marker Lamps
1. Open rear doors.
2. Remove the seven (7) fasteners from the
rear access cover and remove cover to gain
access to the Tail lamp assembly fasteners.
Rear Access Cover
3. Remove the two (2) 17mm tail light
assembly fasteners.
4. Disconnect the tail light harness connector
and remove tail light assembly from the
vehicle.
5. Remove the tail/stop, turn signal, backup
and rear side marker bulb/socket by
rotating counterclockwise.
6. Remove the bulb and replace as needed.
7. Reinstall bulb/socket and rotate clockwise
to lock in place.
8. Reinstall lamp.
REPLACING INTERIOR BULBS
Cargo Lamp
1. Using a suitable tool, remove either the
lamp above the back door or the sliding
door lamp as needed and disconnect it.
Rear Cargo Lamp Bulb Access
2. Using a suitable tool, pull open the metal
bulb access on the back of the housing.
Cargo Lamp Bulb Location
3. Remove and install the replacement bulb.
4. Close the bulb access, connect the lamp
and install the lamp into place.
Dome Lamps
1. Using a suitable tool, insert the tip at the
location shown and press inward to the
lamp to relieve the spring tension. This will
allow you to easily drop the dome lamp
assembly from its bracket and disconnect
the lamp.
20_VF_OM_EN_USC_t.book Page 132
Loading ...
Loading ...
Loading ...