Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 131
6. Rotate the bulb counterclockwise and
remove.
7. Install the bulb into socket, and rotate bulb/
socket clockwise into lamp locking it in
place.
8. Carefully reinstall headlamp in the same
position on the vehicle, so as not to affect
headlamp aiming.
9. Install the one upper retaining screw on
headlamp housing.
10. Install the two lower retaining screws on
headlamp housing.
11. Carefully reinstall the lower headlamp filler
panel and one retaining screw.
12. Carefully reinstall the upper headlamp filler
panel and two retaining screws.
Daytime Running Lamp (DRL)/Front Side
Marker Lamp
1. Remove one retaining screw on the lower
headlamp filler panel. Remove filler panel.
2. Remove two retaining screws on the upper
headlamp filler panel. Remove filler panel.
3. Remove one upper retaining screw from the
headlamp housing.
4. Remove two lower retaining screws from
the headlamp housing.
5. Pull Headlamp forward, disconnect the
harness electrical connector and remove
the headlamp assembly from vehicle.
6. Remove the Daytime Running Lamp (DRL),
side marker bulb by pulling straight out.
7. Replace lamp as required and lock in place.
8. Reinstall plastic cap.
9. Carefully reinstall headlamp in the same
position on the vehicle, as not to affect
headlamp aiming.
10. Install the one upper retaining screw on the
headlamp housing.
11. Install the two lower retaining screws on the
headlamp housing.
12. Carefully reinstall the lower headlamp filler
panel and one retaining screw.
13. Carefully reinstall the upper headlamp filler
panel and two retaining screws.
Front Fog Lamps
1. Turn front wheels inboard to access cover
in wheel liner.
2. Open the cover on the front of the wheel
liner.
3. Remove connection and replace the bulb.
4. Connect the wire and rotate bulb/socket
clockwise into lamp locking it in place.
5. Reinstall the plastic cap and close the cover
on the wheel liner.
Front, Rear Roof Lamps
1. Remove two screw and remove the lamp
assembly.
2. Remove the socket bulb by turning counter-
clockwise.
3. Remove bulb and replace as needed.
4. Reinstall the bulb socket and rotate
clockwise to lock in place.
5. Reinstall lamp.
6
20_VF_OM_EN_USC_t.book Page 131
Loading ...
Loading ...
Loading ...