Loading ...
Loading ...
Loading ...
en-us Troubleshooting
48
Issue Cause and troubleshooting
Display flashes. Appliance door is not closed properly.
▶ Close the appliance door.
‒ Arrange the dishware so that no parts
project beyond the rack and prevent the ap-
pliance door from closing properly.
All LEDs light up or
flash.
Electronics have detected a fault.
1. Press the main switch button for approx. 4sec-
onds.
→
"Controls", Page11
The appliance is reset and restarted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Unplug the power plug or switch off the cir-
cuit breaker in the fuse box.
‒ Wait at least 2minutes.
‒ Switch on the circuit breaker in the fuse box
or plug in the power plug.
‒ Switch on the appliance.
3. If the problem occurs again:
‒ Contact customer service.
→
"Customer Service", Page52
UP appears on the
display.
A software update is available.
▶ Press the remote start button to install the soft-
ware update.
a After a successful software update, "Suc" ap-
pears on the display for a few seconds.
Water is left in the
appliance at the end
of the program.
Filter system or area under the filters is blocked.
1.
Clean the Filters →
Page36
.
2.
Clean the Drain pump →
Page50
.
Program has not yet ended.
▶ Wait until the program ends or terminate the
program with Reset.
▶
→
"Terminating the wash cycle", Page29
Appliance cannot be
switched on or oper-
ated.
Software update is taking place.
▶ Wait until the software update has finished.
Appliance functions have failed.
1. Pull out the power cord plug or switch off the
breaker.
2. Wait at least 2minutes.
3. Connect the appliance to the power supply.
4. Switch the appliance on.
Loading ...
Loading ...
Loading ...