Loading ...
Loading ...
Loading ...
28
FILTER REPLACEMENT
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Use systems
certified for cyst reduction on disinfected
waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gal/453 L for
PurePour PWF-1
ice and water filter
• Rated service flow - .50 gal/min.
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in
2
• Recommended Minimum Operating
Pressure: 30lbs/in
2
Replacing Your Water Filter:
It is not necessary to turn the water
supply o to change the filter. Be ready
to wipe up any small amounts of water
released during the filter replacement.
1. Turn O the ice maker(s).
2. Pull the water filter cover forward
and the cover will drop down to
allow access to the filter.
3. Remove the filter by pushing on
the end/face of the filter (you
should hear a click as the cartridge
disengages the snap-in connector).
Tested and certified by NSF/
ANSI Standards 42, 53, 401 and
CSA B483.1 in
PurePour PWF-1
systems for the reduction
of claims specified on the
performance data sheet.
More about the Advanced
Water Filter
4. Slide the old water filter cartridge
straight out of the housing and
discard it.
5. Unpack the new filter cartridge.
Remove the 2 clear plastic cap
covers on the filter connector. Using
the alignment guide, slide the filter
gently into the filter housing until it
stops against the snap-in connector
at the back of the housing.
6. Push firmly until the cartridge snaps
into place (you should hear a click as
the cartridge engages the
snap-in connector).
7. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
8. Push the cover up toward the liner.
Then push the filter cover toward
the rear of the cabinet. The filter
cover will snap back into place.
9. After filling one glass of water,
continue flushing the system for about
4 minutes. See Priming the water
supply system for more information
10. Reset the filter status on the display.
Press and hold Water Filter for 3
seconds to delay the alert.
11. Turn on the ice maker(s).
Loading ...
Loading ...
Loading ...