Loading ...
Loading ...
Loading ...
Installment
The welding equipment is equipped with power voltage compensation set. When power voltage
changes between±15% of rated voltage, it still works normally.
When using long cable, in order to minimize the reduce of voltage, big cable is suggested. If the
cable is too long, it will affect the performance of arcing and other system function, so stated length is
suggested.
1、Make sure the intake of the machine is not covered or blocked to prevent the malfunction of the
cooling system.
2、Use earth cable that the section no less than 6mm2to connect the housing and earth, the method is
from the connection in the back of the machine to the earth set, or make sure the earth end of power
switch reaches the earth. Both ways can be used for better security.
Installment ,when use gas welding (solid wire)：
1) Connect the gas bottle with CO2regulator flow meter and the Input Gas Connector behind the
machine via gas hose.
2) Insert the cable connector of earth cable into the socket in the front panel.
3) Set the welding wire spool on the wheel axis, the wheel hole should be matched with the wheel
fixer.
4) Choose wire slot according to wire size.
5) Loosen the screw of wire-pressing wheel, put the wire into slot via wire-lead tube, tune the
Wire-pressing wheel to fix wire from gliding, but pressure should be suitable in case the wire distorts
and affects wire sending.
6) Wire roller should turn clockwise rotation to let out wire, to prevent wire from gliding; wire is
usually set to the fixed hole on the wheel side. To prevent the bent wire from getting stuck, please cut off
this part of the wire.
7) The MIG torch has been settled inside of the machine just need put the wire into the torch by hand.
Loading ...
Loading ...
Loading ...