Loading ...
Loading ...
Loading ...
Before You Ca[[
SoButions to Common ProbBems
Before you call for service, review this list. It may saveyou time and expense. The list includes common occurrences that are
not the result of defective workmanship or materials in this appliance. You will be charged for a service call while the appliance
isin warranty if the problem is not caused by defective product workmanship or materials.
Your new appliance is a carefully engineered product. Many times, what appears to bea reason to call for service requires
nothing more than a simple adjustment you can easily make in your own home or isnormal operating characteristic of appliance
under certain conditions.
This list is applicable to a variety of models; some of the items will not necessarily apply to your appliance.
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Range is not level. Poor installation. Place oven rack in center of oven. Place a level on the oven
rack. Adjust leveling legs at base of range until the rack is level. When range is
level, cooktop may appear out of alignment if countertop isnot level.
Weak, unstable floor. Be sure floor is level and can adequately support range.
Contact a carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure
cabinets are square and have sufficient room for range clearance.
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tight. Contact acabinet maker to correct
the problem.
Contact builder or installer to make appliance accessible.
Carpeting interferes with range. Provide sufficient space so range can be lifted
over carpet.
Entire range or oven does not operate. Make sure cord/plug istightly into outlet.
Service wiring isnot complete.
Power outage. Check house lights to be sure. Call your local electric company for
service.
* Oven control beeps and displays F1,
F2, F3or F9
This oven is equipped with astate of the art electronic oven controller. Among the
many features isa full time oven circuit diagnostics system. The controller con-
stantly monitors the internal circuitry aswell asseveral crucial oven circuits to
insure they are all operating correctly. If at any time one of these systems fails, the
controller will immediately stop the current operation and beep continuously
(flashing an error code of "F1, F2, F3", or "F9" in the controller display window.
Electronic control has detected a fault condition. PressSTOP/CLEAR to clear tile
display and stop the beeping. Reprogram oven. If fault remains, record fault
number. PressSTOP/CLEAR and contact authorized servicer.
Oven light does not work. Replace or tighten bulb. SeeChanging Oven Light in this owner's Guide for
instructions.
Surface unit does not heat. No power to the appliance. Check steps under "Entire Range or Oven Does Not
Operate" in this Before you Call checklist.
Incorrect control setting. Make sure the correct control ison for the surface unit to
be used.
Surface units too hot or not hot
enough.
Incorrect control setting. Make surethe correct control ison for tile surface unit to be
used.
Lightweight or warped pans used. Use only flat, evenly balanced, medium or
heavyweight cookware. Flat pans heat better than warped pans. Cookware
materials and weight of the material affect heating. Heavy-and medium- weight
pans heat evenly. Because lightweight pans heat unevenly, foods may burn easily.
25
Loading ...
Loading ...
Loading ...