Loading ...
Loading ...
Loading ...
6. Examine the air filter. Replace the air filter if it is
dirty or damaged. Only use approved Husqvarna air
filters.
CAUTION: Do not bend or fold the air
filter as this can cause damage to the air
filter. Replace a damaged air filter.
To clean a nylon air filter
1. Set the choke control in the choke position.
2. Open the 3 snap locks that holds the air filter cover.
3. Remove the air filter cover.
4. Remove the air filter.
5. Examine and clean the air filter housing with a brush.
6. Examine the air filter. Clean the air filter with warm
soap water. Replace the air filter if it cannot be
fully cleaned or if it is damaged. Only use approved
Husqvarna air filters.
CAUTION:
Do not bend or fold the air
filter as this can cause damage to the air
filter. Replace a damaged air filter.
To change from a paper air filter to a nylon air
filter
Use a nylon air filter when the temperature is below 5°C/
41°F.
1. Set the choke control in the choke position.
2. Open the 3 snap locks that holds the air filter cover.
3. Remove the air filter cover.
4. Remove the air filter.
5. Examine and clean the filter housing with a brush.
6. Examine the filter. Replace the filter if it is dirty or
damaged.
7. Install the nylon air filter correctly.
8. Attach the air filter cover.
9. Close the 3 snap locks that holds the air filter cover.
CAUTION: Do not bend or fold the filter
as this can cause damage to the filter. A
damaged filter must always be replaced.
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A B
1018 - 011 - 07.06.2023
25
Loading ...
Loading ...
Loading ...