Tripp Lite SMART1200XLHG Owner’s Manual

Loading ...

Quick Installation

For All Models—Plug your UPS into a

3-wire grounded, 120V AC, 60 Hz utility

outlet.

Note: UL 60601-1 listed UPS systems only meet UL standard UL

60601-1 for medical equipment when plugged into a hospital-grade

outlet.

Note: UPS system will function properly upon initial startup; however,

maximum runtime for the unit’s battery will only be accessible after it

has been charged for 24 hours.

Note: Although some installation procedures are common to all models, some procedures

vary depending on whether you are installing a SmartPro model or an OmniSmart model.

For All Models—Plug your equipment into

the UPS.

You will overload the UPS if the total VA ratings for all of the

equipment you connect exceeds the UPS Output Capacity. To

ﬁnd your equipment’s VA ratings, look on their nameplates. If the

equipment is listed in amps, multiply the number of amps by 120 to

determine VA (Example: 1 amp x 120 = 120VA). If you are unsure

if you have overloaded the outlets, see “OUTPUT LOAD LEVEL” LED

description.

For SmartPro Models Only—

Turn the UPS ON.

Press and hold the “POWER” button for one second. The

alarm will beep once brieﬂy after one second has passed.

Release the button.

For OmniSmart Models Only—

Select UPS Operating Mode.*

For SmartPro Models Only:

After you plug the UPS into a live AC outlet, the UPS will automatically charge its batteries

but will not supply power to its outlets until it is turned ON (see Step 3 below). The BATTERY

CHARGE LED will be the only LED illuminated.

For OmniSmart Models Only:

Your UPS will run a self-test after it is plugged in. See Basic Operation section to understand

the results of its self-test.

Press the UPS/STANDBY button to toggle your UPS between the UPS (“POWER” LED lit) and

the STANDBY (“POWER” LED ﬂashing) modes. Choose the operating mode based on your

location:

USA, Canada and Western Europe:

• Leave the UPS in the UPS mode at all times.

All Other Countries:

• Put the UPS in STANDBY mode when you are not using connected equipment.

IMPORTANT! When set to “CHARGE ONLY,” the UPS will not provide battery backup

during a blackout or brownout.

• Put the UPS in UPS mode when you are using connected equipment.

*See Basic Operation section for a complete explanation of each mode.

Loading ...

Tripp Lite SMART1200XLHG SmartPro 120V 1kVA 750W Medical-Grade Line-Interactive Tower UPS, 4 Outlets, Full Isolation, Expandable Runtime

Owner’s Manual - Page 6