Loading ...
Loading ...
Loading ...
Thread tension
Note:
The bobbin thread tension has been adjusted
at the factory and readjustment is usually not
required.
Lower thread tension
To test the bobbin thread tension, remove the
bobbin case and bobbin from the machine and
hold the bobbin case suspended by the thread.
Shake it once or twice, if the tension is correct,
the thread will unwind by about an inch or two.
if the tension is too tight, it will not unwind, if
the tension is too loose, the thread will unwind
for more than two inches.
To adjust, turn the small screw on the side of
the bobbin case. (1)
Upper thread tension
Basic thread tension setting: "4". (2)
To increase the tension, turn the dial up to a
higher number. To reduce the tension, turn the
dial to a lower number.
A. Normal thread tension.
B. Thread tension too loose.
C. Thread tension too tight.
0 Tension del hilo
Tension del hilo inferior
Para controlar la tensi6n del hilo inferior coger
el porta-canillas Ileno por la punta del hilo y
dejarlo colgado en el aire. Si la canilla no se
desenrolla mientras el porta-canillas se oscila
ligeramente, entonces la tension es
demasiado fuerte. Pero si en cambio se cae al
suelo o se devana muy facilmente, entonces la
tensi6n es muy fioja.
La tensi6n es correcta cuando el porta-canillas
baja unos 10 cm y despues se para colgado al
hilo.
Atencion:
Normalmente no es necesario cambiar la
tension del hill inferior.
Tension del hilo superior
Regulaci6n de base de la tensi6n del hilo: "4".
Para aumentar la tension del hilo superjor hay
que girar el boton de regulaci6n hacia un
nOmero m_.s alto.
Para afiojar la tensi6n del hilo se gira dicho
boton hacia un nOmero m_.s bajo.
A. Tensi6n del hilo normal
B. Tensi6n del hilo superior muy fioja
C. Tensi6n del hilo superior demasiado fuerte
0 Tension du fil
Note:
Norma/ement /a tension du fi/ inferieur ne dolt
pas _tre modifiee.
Tension du fil inferieur
Pour verifier la tension du fil inf_rieur, retirer le
bo'_tier & canette et tenez-la suspendue par le
ill. La tension du fil est correcte Iorsque le fil se
d_roule vers le bas de 5 & 10cm env. quand on
lui imprime un leger balancement (la canette
dolt _tre pleine Iors du test). Si la tension est
trop serree, le fil se d_roule tres difficilement ou
pas du tout. Si la tension est trop faible, le fil se
d_roule trop vite. Pour ajuster, tourner la vis
sur le c6t_ du bo'_tier.(1)
Tension du fil superieur
Position de reference de la tension du ill: "4" (2)
II faut que la tension des ills soit equilibree
correctement. S'il s'avere necessaire de la
modifier, ce reglage s'effectue normalement en
changeant la tension du fil sup_rieur. Pour le
point zigzag, la tension correcte est que le fil
superieur apparaisse legerement sur I'envers
du tissu.
A. Tension normale
B. Tension du fil sup_rieur trop I&che
C. Tension du fil superieur trop serree
29
Loading ...
Loading ...
Loading ...