Loading ...
Loading ...
Loading ...
16
Regulator and hose replacement
The pressure regulator and hose assembly supplied with the unit must be used. If
replacements are needed, contact customer care at dcsappliances.com.
Resetting the flow control
Failure to follow the steps in the order shown may cause the Flow Limiting Device to
activate resulting in extremely low gas flow and irregular operation.
1 All dials must be in the
OFF position.
2 Attach regulator hose assembly to the tank and open the LP tank valve (minimum of
two full turns).
Stainless Steel
Always use the mildest cleaning method first. Do not use steel wool to clean the product as
it will scratch the surface.
Burner trivets
For durability and optimal performance, the burner trivets have been crafted using Stainless
Steel. It is recommended that the trivets are cleaned while in place, however if removing
the trivets take care as they are heavy and ensure they are placed on a protected surface.
Trivets can be cleaned using hot soapy water.
Due to rapid temperature changes the Stainless Steel will slowly darken over time. This is
normal and will not impact the products performance.
Drip tray
To clean the drip tray, pull tray forward to remove. Wipe spills as soon as possible to
prevent them becoming baked on.
Cleaning burner parts
3 Ensure all burner dials are
OFF and all surfaces are cool.
4 Remove the burner cap and port ring and wash in hot soapy water, rinse and dry. The
burner ports can be cleaned using a bristled brush.
Do not disassemble the burner, doing so could result in a fire hazard or explosion.
5 After cleaning, ensure the locating pins are correctly aligned. Incorrect alignment can
cause poor burner performance and uneven or irregular flames.
Cap
Port ring
Igniter
Locating pins
Locating holes
Locating notch
CARE AND CLEANING
Loading ...
Loading ...
Loading ...