Loading ...
Loading ...
Loading ...
18
POWER BRUSH (ELECTRIC KITS ONLY) (CONT'D)
HOW TO USE POWER BRUSH/WAND
WAND RELEASE
The power brush is not
recommended for use
on bare floors. Wand
release pedal (A) on
power brush allows you
to quickly disconnect
wand and switch to
combination floor/rug
tool for use on bare
floors.
POWER BRUSH NECK RELEASE
Push down power brush neck release pedal (B) to unlock
brush neck. Return the neck to the upright position for storage.
POWER BRUSH HEIGHT ADJUSTMENT
The icons (D) refer to the carpet pile
height. Select height by depressing
height adjustment pedal (C) to desired
position: (Extra-Low), (Low),
(Medium) or (High).
HEIGHT ADJUSTMENT LED INDICATORS
The LEDs show the carpet pile covered by
the selected height, e.g.: when (High)
is selected, all LEDs will be lit, since
this height covers all pile heights. So if
(Extra-Low) is selected, only the lowest LED will be lit.
WAND LENGTH ADJUSTMENT
Extend (E) or shorten (F) the
wand to comfortable work
position by holding the wand
grip (G) in one hand and
sliding the upper section (the
one with the prongs) with the
other hand.
EDGE CLEANER
Brush extends full width for effective edge cleaning along both
sides of nozzle. To operate, simply run cleaner along edge
board. Rubber bumper protects furniture and baseboards.
ELECTRONIC CIRCUIT BREAKER
The power brush is equipped with an electronic circuit brea-
ker that protects the motor and the belt if a too large object is
picked up accidentally.
If the power brush stops while
vacuuming, turn the power unit
off using handle. Release the
power brush from the wand
and turn it over to see if there
is an obstruction. When brush
roll jam has been cleared,
press the reset button (H) and
connect the power brush back
to the wand. Finally, turn the
power unit/power brush back on. If it fails to restart or continues
to trip without any apparent reason, the power brush must be
serviced by an authorized service center.
CLEANING AND STORAGE
BRUSH ROLL
In order to keep high cleaning efficiency and to prevent
damage to your vacuum cleaner, the brush roll must be cleaned
every time the belt is changed.
The brush roll must also be cleaned according to the following
schedule:
VACCUM CLEANER USE CLEAN BRUSH ROLL
Heavy (used daily) Every week
Moderate (2-3 times per week) Every month
Light (once a week) Every 2 months
Check and remove hair, string and lint build-up frequently in
the brush roll and end cap areas. Remove any dirt or debris in
the belt path and in the brush roll areas.
HOUSING
To keep the power brush housing clean, it can be wiped with
a damp cloth and a mild soap solution, then thoroughly dried.
Never use any type of chemical as they can damage the housing.
STORAGE
Ensure that hose and power cord are disconnected from
wall inlet before unplugging power brush.
Disconnect hose handle from wand.
Always keep hose neatly coiled when not in use.
When not in use, the power brush should be stored in a
clean, dry place.
CAUTION
Always pick up hard or sharp objects by hand
before using your power brush. Items such as
pins, hairpins, tacks, crayons, etc., may damage
the brush roll or may break the belt.
WARNING
!
Disconnect electrical supply before servicing or
cleaning the unit. Failure to do so can result in
electrical shock or personal injury from cleaner
suddenly starting.
AO0020
A
B
C
CAUTION
Always unlock brush neck before use.
AD0022
FLOOR HEIGHT
D
AD0024
E
F
AD0023
G
AD0030
H
Loading ...
Loading ...
Loading ...