Loading ...
Loading ...
Loading ...
11
12. Grab the back paper that you folded earlier, pull it upwards over the roller and hold while moving
the roller over the remaining part of the substrate. Please pay attention to holding the media in the
center as well as straight over the roller as you go.
13. Please have a look at the videos found on www.rollover.no to have a visual impression of the
applications.
How to mount application tape
1. Attach the brackets/spindle to the housing as seen below, and place the roll of application tape (with
the glued side facing away from the roller) resting between the roller and the spindle. Fold and glue an
inch or so at the end of the tape to avoid it from sticking to the roller or spindle.
2. Grab and pull the application tape, bringing it under the roller with the glued side facing downwards.
Tighten/straighten the tape properly and see to that there are no wrinkles.
3. Lower the roller 2 – 3’’ from the end of the material as a starting point making the application tape
stick to the table.
4. Pull the roller across the entire surface of weeded vinyl while applying the tape, then bring the roller
to the upper position and cut the application tape with a sharp cutter.
Maintenance and adjustments.
Adjust speed and parallelism - up/down motion of the roller.
Elevation speed of the roller can be adjusted individually on each side of the housings:
1. Use the adjustment screws (Marked A and B in the picture below) to adjust parallel lifting and lowering of
the roller on each side. You can use a standard flat screwdriver.
2. Use the same adjustment screws to either increase or reduce the speed of lifting/lowering the roller.
Turn the upper adjustment screws (A) clockwise to reduce speed when lifting the roller. Turn the adjustment
screws anti-clockwise to increase speed when lifting the roller.
3. Turn the lower adjustment screws (B) clockwise to reduce speed when lowering the roller. Turn the
adjustment screw anti-clockwise to increase speed when lowering the roller.
Loading ...
Loading ...