Loading ...
Loading ...
Loading ...
41 42
Problem
Rinse Aid light on
Dishwasher won't start
Dishwasher operates too
long
Dishes are not clean
enough
Dishes are not drying
Spots and film on dishes
Etching
Power supply or power
line is not connected
Delay start option has
been selected
Rinse aid dispenser is
empty
Improper dish loading
The chosen cycle does
not include drying
Fill rinse aid dispenser
Re-load dishes
according to manual
Choose a different
cycle with drying
The dishwasher is
connected to cold
water
The cycle time will vary
according to soil level
The sanitize option is
selected
Water is too hard
Improper dish loading
Old rinse aid
Rinse dispenser empty
Too much detergent
Inlet water temp
exceeds 158°F
Use less detergent
Lower inlet water temp
Install water softener
Re-load the dishes
Use fresh rinse aid
Add rinse aid
Water pressure is
temporarily low
The inlet water
temperature is low
Dishes are loaded too
close together
The selected cycle is
not suitable for soil
condition
Spray arms are
blocked
Try again when water
pressure is normal
Make sure hot water is
connected
Re-load dishes
according to manual
Choose another cycle
with a longer wash time
Unblock spray arms
Make sure the
dishwasher is
connected to hot water
The cycle will increase
based on soil level
The cycle will increase
when using sanitize
Check and connect
power supply
Refer to delay start
section in this manual
Possible Cause
Solution
LED screen show "LSb"
Add rinse aid
TroubleshootingTroubleshooting
Problem
Detergent dispenser won't
close
Detergent left in dispenser
Water remains in the
dishwasher
Dishwasher does not drain
properly
Suds in the tub
Noises
Dishwasher leaks
Black or gray marks on
dishes
Stained tub interior
Dishwasher won't fill
Detergent may be too
old
Spray arm is blocked
Improper detergent
was used
Improper detergent
was used
Dishwasher is not level
Aluminum utensils
rubbed against dishes
Coffee and tea soil
Reddish stain
Use an approved spot
cleaner to remove soil
Use the rinse only cycle
right after loading to
decrease staining
Rearrange dishes and
make sure water inlet is
no less then 120°F
Only use automatic
dishwasher detergent
Level the dishwasher
Only use automatic
dishwasher detergent
Previous cycle has not
finished or has been
interrupted
Detergent cup is open
A hard object entered
the wash module
This is normal
If noise persists, call for
service
Water valve is off
Door latch may not be
properly sealed
Turn on water valve
Make sure door is
closed
Drain is clogged
Drain hose is kinked
Check the air gap if
you have one. Make
sure the disposer is
empty if the dishwasher
is connected to one
Make sure the drain
hose is properly
connected to the sink
Select the proper cycle
Use fresh detergent
Unblock spray arms
Possible Cause
Solution
Improper operation of
the detergent cover
Add detergent and rise
aid as indicated
Loading ...
Loading ...
Loading ...