Loading ...
Loading ...
Loading ...
10.3 REMOVE EXCESS LINE
1. Push the tabs (19) on the sides of the trimmer head at the
same time.
19
2. Pull and remove the spool cover (20).
19
20
21
22
3. Remove any remaining line.
4. Clean dirt and debris from all parts. Replace spool (22) if
it is worn or damaged.
5. Align the spool tabs (19) with the tab openings in the
base of the spool.
6. Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
NOTE
Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cover with the slots (24) on
the trimmer head.
24
23
3. Insert the line into the mounting hole, which is located
inside the eyelet (23). Push the cutting line until it exits
the opposite hole.
23
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Rotate the spool cover clock-wise in the arrow direction
to wind the cutting line into the trimmer head. Keep
approximately 5 in of cutting line above out of each side
of the trimmer head.
10
English
EN
Loading ...
Loading ...
Loading ...