Loading ...
Loading ...
Loading ...
Press [Setting] > Frequency softkey on the front panel, and then use the numeric keypad or
direction keys and knob to input the desired frequency value.
5.10.4 Modulation Source
3FSK uses internal modulation source. The modulating waveform is square.
5.10.5 3FSK Rate
When internal modulation source is selected, press [Mod] > Rate softkey to set the rate at which
the output frequency shifts between "carrier frequency" and two "hopping frequencies".
Use the numeric keypad or direction keys and knob to input the desired rate value.
The rate range is from 2mHz to 1MHz and the default is 100Hz.
5.10.6 HoppingFrequency
The range of hopping frequency depends on the carrier waveform currently selected. Refer to
"Frequency Characteristics" in "
Specifications".
Press [Mod] > Hopping softkey. Use the numeric keypad or direction keys and knob to input the
desired frequency value.
5.11 4FSK Modulation
Users can configure the instrument to "shift" its output frequency between four preset values
using 4FSK modulation. The rate at which the output shifts between the four frequencies (called
the "carrier frequency" and three "hop frequencies") is determined by the internal signal level of
the instrument.
5.11.1 Select 4FSK Modulation
Press [Mod] >Type > 4FSKsoftkey to enable 4FSK function.
When Mod is enabled, Sweep or Burst will be disabled automatically.
After 4FSK is enabled, the instrument will generate 4FSK waveform with the currently specified
carrier and modulating waveforms. To avoid multiple waveform changes, enable modulation
after configuring the other modulation parameters.
5.11.2 Carrier Waveform Shape
4FSK carrier shape: Sine (default), Square, Ramp, Pulse, Arbitrary (except DC) or Harmonic
waveform.
Press[Wave] button on the front panel to select the desired carrier waveform.
Noise and DC could not be used as carrier waveform.
User Manual 49
Loading ...
Loading ...
Loading ...