Craftsman 13953663SRT 1/2-hp garage door opener

User Manual - Page 32

For 13953663SRT.

PDF File Manual, 40 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Operation of Your Opener
Activate the opener with any of the following:
The Remote Controh Hold push button down until the
door starts to move.
The Door Control: Hold push bar or button down until
the door starts to move.
The Outdoor Key Switch or Keyless Entry: (See
Accessories)
When the opener is activated with the safety reversing
sensor installed and correctly aligned:
1. If open, the door wilt close. If closed, the door witl
open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space t\_rentry
and exit of pets and for fresh air).
4. If the door has been stopped in a partially open position,
it will close.
5. If obstructed while closing, the door wilt reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle when
the invisible beam is broken. If fully open, the door will
not close when the beam is broken. The sensor has no
effect in the opening cycle.
If the sensor is not installed, or is not atiNled correctly, the
door won't close from any remote control. You can close
the door with the Door Control, the Outdoor Key Switch,
or Keyless Entry, however, if you activate them until down
travel is complete. If you release them too soon, the door
will reverse.
The opener lights will blinkJbr 5 seconds when the safety
reversing sensor causes the door to reverse.
The Opener Lights will turn on under the following
conditions: When the opener is initially plugged in; when the
power is interrupted; when the opener is activated. They wilt
tum off automatically after 4-1/2 minutes or provide
constant light when the Light feature on the Premium
Control Console is activated. SECURITY+ models:
Lights will also turn on when someone walks through the
open garage door. Bulb size is 75 watts maximum.
Weakor brokenspringscouldallowan open doortofall
(either rapidly or unexpectedly), resulting in serious
injury, death or property damage.If possible, usethe
manualreleaserope andhandle onlywhen thedoor is
fullyclosed.
_lw_ Trolley
ReleaseArm
(in Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
To open the door
manually:
The door should be fully
closed if possible. Pull down
on the elnergency release
handle (so that the trolley
release arm snaps into a
vertical position) and lift the
door lnanually. The lockout
feature prevents the trolley
from reconnecting auto-
lnatically, and the door can
be raised and lowered
manually as often as
necessary.
To reengage the trolley:
Pull the elnergency release
handle toward the opener at
a 45° degree angle so that
the trolley release arm is
horizontal. The trolley will
reconnect on the next UP or
DOWN operation, either
lnanually or by pressing the
Door Control push button.
_L_ Trolley
_, '_Release Arm
Emergency _,
Release _ _.
Handle _
(Pult at 45 ° angte)
To reconnect
Operation of the Door Controls (see page 21)
(SECURITY÷ models: See additional progralnlning features, next page.)
Press the lighted push button to open or close the door.
Press again to revels'e the door during the closing cycle
or to stop the door while it's opening.
Premium Console:
Li@tfeamre." Press the large round Light button. It"the
opener light is off it will mm on. If the opener light is
on, (even in the 4-1/2 minute autolnatic cycle) it will
turn oj_."
Bm if you use the Light button to turn the lights on and
then activate the opener, the lights will turn offafter 4-
1/2 minutes.
The Light button will not control the opener lights when
the door is in lnotion.
Premium Console (cont.):
Lockfoatm_e. The Lock feature is designed to prevem
operation of the door from remote controls. However,
the door will open and close from the Door Control, the
Outdoor Key Switch and the Keyless Entry Accessories.
To activate. Press and hold the small round Lock
button for 2 seconds. The push button light will flash
as long as the Lock feature is on.
To turn of_ _Press and hold the Lock button again for
2 seconds.The push button light will stop flashing. The
Lock feature will also turn off whenever the SRT
button on the opener panel is activated.
32
Loading ...
Loading ...
Loading ...