Loading ...
Loading ...
Loading ...
Risk of Unsafe Operation. Unit cycles automatically when power
is on. When servicing, you may be exposed to voltage sources,
compressed air, or moving parts. Before servicing unit unplug or disconnect
electrical supply to the air compressor, bleed tank of pressure, and allow the air
compressor to cool.
PROBLEM CAUSE CORRECTION
Excessive Pressure switch does not Move Auto/Off lever to the
tank pressure shut off motor when "Off" position, if the outfit
- safety valve compressor reaches does not shut off contact a
pops off. "cut-out" pressure. Trained Service Technician.
Pressure switch "cut-out" Contact a Trained Service
too high. Technician.
Air leaks at fit- Tube fittings are not tight Tighten fittings where air can
tings, enough, be heard escaping. Check
fittings with soapy water solu-
tion. Do Not Overtighten.
Check valve seat damaged.
Air leaks at or
inside check
valve.
A defective check valve results
in a constant air leak at the
pressure release valve when
there is pressure in the tank
and the compressor is shut
off. Replace check valve.
Refer to the To Replace
Check Valve in the Service
and Adjustment section.
Air leaks at Defective pressure switch Contact a Trained Service
pressure switch release valve. Technician.
release valve.
Defective air tank.Air leaks in air
tank or at air
tank welds.
Air tank must be replaced. Do
not repair the leak.
_Risk of
-- Bursting
Do not drill into, weld or
otherwise modify air tank or
it will weaken. The tank can
rupture or explode.
Air leaks Leaking seal. Contact a Trained Service
between head Technician.
and valve plate.
21-ENG N022059
Loading ...
Loading ...
Loading ...