Loading ...
Loading ...
Loading ...
17
ASSEMBLY
8a. Hardware Removal- Remove the two Phillips Screws (88) from the back of the Console (53).
Then remove the two Socket Hex Bolts (38) and two Curve Washers (93) from the Front Post (5).
8b. Console Installation - Insert the Hand Pulse Sensor Wires (101) from the Handlebar (6) into the
hole on the forward facing side of the Front Post (5), and pull them up, and out of the top end of the
Front Post (5). Connect the Hand Pulse Sensor Wires (101) to the Sensor Wires coming from the
back of the Console (53). Then connect the Sensor Wire I (64) to the connection Sensor Wire coming
from the back of the Console (53) (See Fig. E). Place the Console (53) onto the plate on the Front
Post (5) and secure it into place using the two Bolts (88) and tighten using the Multi Hex Tool with
Phillips Screwdriver provided.
8c. Handlebar Installation - Attach the Handlebar (6) onto the Front Post (5) using the two Bolts (38)
and two Curve Washers (93) that were previously removed. Then tighten using the 6mm Allen
Wrench provided.
6mm Allen Wrench
1PC
TOOL
Multi Hex Tool with Phillips
Screwdriver
1 PC
Loading ...
Loading ...
Loading ...