Loading ...
Loading ...
Loading ...
Configuring Schedule Alarm
Settings
With the [SCH] (schedule) alarm type, you can
specify the year, month, and day that you want
an alarm to sound.
●
Creating a Schedule Alarm
There are various schedule alarm variations,
and the variation that is set depends on the
year, month, and day settings you configure.
Three typical setting configurations are shown
below, but other configurations are also
possible.
A Year, month, day all specified
The alarm sounds once at the specified
time on the specified date.
B Year, month, day partially specified
●
Specifying only the year will cause the
alarm to sound at the specified time
every day of the specified year.
●
Specifying only the month and day will
cause the alarm to sound at the
specified time on the specified date
every year.
You can also create a schedule alarm by
specifying the month only, day only, year
and month only, and year and day only.
C Year, month, day not specified (Display:
[----], [--.--])
In this case, the alarm will sound at the
specified time every day.
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (E) to scroll through alarm numbers
([AL1] to [AL5]) until the alarm you want to
configure is displayed.
Alarm number
Alarm time
3. Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
Hours
4. Use (B) and (E) to change the hour setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (D).
This causes the minutes digits to flash.
Minutes
6. Use (B) and (E) to set the minute setting.
7. Press (D).
This causes the alarm type to flash.
8. Press (E) to display [SCH].
9. Press (A).
This displays a screen for setting the year,
month, and day.
●
Use (B) and (E) to change the flashing
setting.
●
Use (D) to move between setting items
(year, month, day).
Month
Ye a r
Day
10.
Press (A) to exit the setting screen.
Enabling the Hourly Time
Signal
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (E) to display the hourly time signal
screen ([SIG]).
3. Press (A) to toggle the hourly time signal
between enabled and disabled.
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
Watch Operation Guide 5707
20
Loading ...
Loading ...
Loading ...