Loading ...
Loading ...
Loading ...
28
©
2022 DJI All Rights Reserved.
DJI Mini 3 Pro
User Manual
Move the pitch stick forward or backward, and the aircraft will y over, under, or to the left or right of the
obstacle. The aircraft can also respond to the control stick inputs while avoiding obstacles.
When APAS is enabled, the aircraft can be stopped by pressing the Flight Pause button on the remote
controller. The aircraft will hover for three seconds and await further pilot commands.
To enable APAS, open DJI Fly, enter System Settings, Safety, and enable APAS by selecting Bypass.
Landing Protection
Landing Protection will activate if Obstacle Avoidance is set to Bypass or Brake and the user pulls the
throttle stick down to land the aircraft.
Landing Protection is enabled once the aircraft begins to land.
1. During Landing Protection, the aircraft will automatically detect and carefully land on suitable ground.
2. If the ground is determined unsuitable for landing, the aircraft will hover when the aircraft descends
to 0.8 m above ground. Pull the throttle stick down for more than ve seconds and the aircraft will
land without obstacle avoidance.
APAS is disabled when using Intelligent Flight Modes. It will be enabled automatically once the aircraft
exits Intelligent Flight Modes. APAS is disabled when recording at a high resolution such as 1080p
120 fps, 2.7K 48/50/60 fps, or 4K 48/50/60 fps.
APAS is only available when ying forward, backward, and downward. APAS is not available when
the aircraft is ying leftward, rightward, or upward, and no bypass or obstacle avoidance in these
cases.
Make sure to use APAS when the Vision Systems are available. Be sure there are no people, animals,
objects with small surface areas (e.g., tree branches), or transparent objects (e.g., glass or water)
along the desired ight path.
Make sure to use APAS when the Vision Systems are available or the GNSS signal is strong. APAS
may not function properly when the aircraft is ying over water or snow-covered areas.
Be extra cautious when ying in extremely dark (<300 lux) or bright (>10,000 lux) environments.
Pay attention to DJI Fly and make sure the aircraft is working normally in APAS mode.
APAS may not function properly when the aircraft is ying near ight limits or in a GEO zone.
Flight Recorder
Flight data including ight telemetry, aircraft status information, and other parameters are automatically
saved to the internal data recorder of the aircraft. The data can be accessed using DJI Assistant 2
(Consumer Drones Series).
Propellers
There are two types of DJI Mini 3 Pro propellers, which are designed to spin in dierent directions. The
marked propellers should be attached to the marked motors, and unmarked propellers to the unmarked
motors. The two propeller blades attached to one motor are the same. Make sure to match the
propellers and motors by following the instructions.
Loading ...
Loading ...
Loading ...