Loading ...
Loading ...
Loading ...
15
TROUBLE SHOOTING
Nothing happens when I t to vacuum package
1. Check power cord to see if it is rmly plugged into electrical outlet.
2. Examine power cord for any damages.
3. See if electrical outlet is operative by plugging in another appliance.
4. If your appliance has a mode switch, make sure it is set to the correct mode.
Refer to the above operating instructions
5. Make sure bag is placed correctly inside Vacuum chamber and beneath the air
intake.
Air is not removed from the bag completely:
1. To seal properly, open end of bag should be resting entirely inside vacuum
chamber area.
2. Check sealing strip and the foam gasket beneath the lid for debris and
position. Make sure no breaking or distoion of the foam seal gaskets on both the
cover and on the base around the vacuum chamber. Wipe clean and smooth them
back into place.
3. Vacuum bag may have a leak. To test, seal the bag with some air in it,
submerge in water, and apply pressure. Bubbles indicate a leak. Reseal or use
another bag.
4. Uses only the specic vacuum bag with vacuum channels provided by the
manufacturer.
5. Leaks along the seal which can be caused by wrinkles, debriscrumbs, grease or
liquids. Reopen bag, wipe the top inside of the bag and smooth it out along the
sealing strip before resealing.
The machine does not turn to seal after vacuuming:
1. There is a vacuum pressure sensor built in this machine. The machine will not
turn to seal automatically if the vacuum pressure inside the bag is not able to reach
to the predetermined vacuum pressure. Check sealing strip and the foam gasket
beneath the lid for debris and correct position. Wipe clean and smooth them back
into place, and t again.
2. Make sure no breaking or distoion of the foam seal gaskets on both the
cover and on the base around the vacuum chamber. Take it out from the groove,
wash and d it thoroughly; or replace with a new foam gasket (get it from where
you brought or your nearest seice center).
3. Vacuum bag may have a leak. To test, seal the bag with some air in it,
submerge in water, and apply pressure. Bubbles indicate a leak. re-seal or use
another bag.
4. Leaks along the seal which can be caused by wrinkles, debris crumbs, grease or
liquidsfrom the bag. Reopen bag, wipe the top inside of the bag and smooth it out
along the sealing strip before resealing.
Loading ...
Loading ...
Loading ...