Loading ...
Loading ...
Loading ...
PRODUCT OPERATION
TROUBLESHOOTING (cont.)
The toilet tank is filling up
slower than normal after
installing the bidet.
Water sprays straight
down into the toilet tank
instead of upwards during
use.
When the bidet is turned
on, no water comes out of
the nozzle.
The nozzle(s) are spraying
off-center or to the side.
The water supply valve
may not be fully opened.
The nozzle cap(s) that
screw onto the bottom of
the nozzle(s) is missing.
1. There may be hard
water deposit(s) in or
around the nozzle.
2. The water flow knob /
lever is not turned on.
3. The t-adapter is not
connected properly.
4. The toilet seat or bowl
is blocking the nozzle(s)
from extending.
1. The nozzle(s) holes are
not facing foward properly.
2. The bidet is not
installed completely
straight.
Turn the water supply
valve clockwise to allow
more water to flow to the
toilet.
A replacement nozzle cap
can be purchased on the
Accessories page on
luxebidet.com.
1. Gently pull the nozzle
up and down a few times
to loosen it, or you can
also try cleaning it with
paper towels soaked in
vinegar to safely dissolve
any hard water build up.
2. Turn the nozzle mode
knob to ‘Wash’ and turn /
lift the water flow knob /
lever to activate the bidet.
3. Check that the t-adapter
is tightened all the way so
water can flow through it.
4. Reposition the bidet on
the toilet bowl to create
clearance for the nozzle(s).
1. Open the guard gate to
allow access to the
nozzle(s), then fully retract
the nozzle(s) into the bidet
and turn the nozzle(s)
counter-clockwise until
the holes face forward.
2. Adjust the positioning of
the bidet on the toilet by a
few degrees.
Problem Possible Causes Possible Solutions
11
Loading ...
Loading ...
Loading ...