Loading ...
Loading ...
Loading ...
( ELECTMODELS),CONTo
NOTE: These directions pertain to 5-button controls only. If your unit has LCD controls, please refer to the information booklet
located in your literature packet.
ICE DISPENSER
OPERATION
To dispense ice:
Select CUBE or CRUSH ice mode by
pushing button on dispenser control
panel. A green indicator light above
button shows mode selection.
Press container
against dispenser
pad. When dis
ing crushed ice, hold
container as close to
chute as possible to
reduce spraying. Selection mode
may not be changed while ice dis-
penser is in operation.
NOTE: If dispenser is active for more
than 3 minutes, an automatic lock out
sensor will shut down power to dis-
penser area. See Dispenser Lock for
unlocking information.
DISPENSER LOCK
(SOME MODELS)
This feature prevents ice or water from
being dispensed.
To lock dispenser:
Press and hold LOCK/UNLOCK
button for 3 seconds. A green indica-
tor light above button confirms dis-
penser is locked.
To unlock dispenser:
Hold LOCK/UNLOCK button for 3
seconds. Green indicator light above
button will go out.
FILTER STATUS F,,T
INDICATOR LIGHT °
(SOME MODELS) • o,
° C/tANGE
The filter status indicatorlight
serves as a reminder to replace the
water filter. A green light indicatesthat
the filter is in good condition. A red light
indicatesthe filter should be changed.
Once light turns red, it will remain red
until function is reset.
To reset indicator:
Press and hold both LOCK/UNLOCK
and WATER buttons simultaneously
for 4 seconds. The green filter status
indicator light will flash 3 times when
the function has successfully reset.
o
AUTO LIGHT
(SOME MODELS)
The Auto Light function
offers the ability to activate the
dispenser light at half-power when the
Light Sensor detects that the light lev-
els in room are low.
To
activate Auto Light:
Press ON/OFF button located on
control panel. A green indicator light
above button displays to show that
sensor is active.
To deactivate Auto Light:
Press ON/OFF button. Green indica-
tor light will go out.
NOTE: Dispenser light will operate
whether or not Auto Light is selected.
SABBATH MODE
(SOME MODELS)
This mode is intended to
deactivate power to the LED
and dispenser lights, while
allowing the controls to remain opera-
tional.
To activate Sabbath Mode:
Press and hold both LOCK/UNLOCK
and ON/OFF buttons simultaneously
for 3 to 4 seconds. After 3 to 4 sec-
onds, the LED and dispenser lights
will turn off. Dispenser light will not
activate during dispensing while in
this mode.
To deactivate Sabbath Mode:
Press and hold both LOCK/UNLOCK
and ON/OFF buttons simultaneously
for 3 to 4 seconds. After 3 to 4 sec-
onds, the LED and dispenser lights
will activate.
NOTE: In the event that power is inter-
rupted while the Sabbath Mode is active,
the control will remain inSabbath Mode
when power returns.
Loading ...
Loading ...
Loading ...