Loading ...
Loading ...
Loading ...
Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODELS
WSLS1100 AND WSLM1100 (CONT.)
[] INSTALLATION CHECKLIST
Before starting the washer, check to make sure:
Main power is turned on.
The washer is plugged in.
The water fimcets are turned on.
The unit is level.
The drain hose is properly fled up.
There are no leaks at the fimcet, drain line
or washei;
[] RUN THE WASHER THROUGH A
COMPLETE CYCLE
Check for water leaks and proper operation.
[] REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
[] READ THE REST OF THIS
OWNER'S MANUAL
It contains _aluable and helpflfl infimnation that will
sa'_e _()11 [lille and iilonev.
OWNERS
MANUAL
NOTE: If yore" washer does not operate, please review
the Before YouCall For Service section.
ALCOVE OR CLOSET INSTALLATION
If _,om" washer is approxed fin" installation in an
alcoxe or closet, there will be a label on the back
of the machine describing reqtfirements.
• Minimum/clearances between washer and a(!jacent
walls or other suriaces are: 0" either side, _ " "2 front,
._tt I'e_l I'.
• Minimum vertical space fl'om floor to overhead
shelves, cabinets, ceilings, etc. is 96'.'
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches open
area fl)r washer only, or if the closet contains both
a washer and dryer, doors must contain at least
120 square inches of open area equally distributed.
NOTE: The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances fin" installation
and servicing.
[ ]
0
l 1
! !
Closet door
60sq.in.
(387.1sq.cm)
60 sq. in.
(387.1 sq. cm)
12
Loading ...
Loading ...
Loading ...