Loading ...
Loading ...
Loading ...
8
Installation
Overview
This appliance requires a ductwork that leads to
outdoors through the wall or roof.
• For installation without an existing ductwork,
determine the route to run the ductwork and
source the ducts and wall/roof cap locally.
• For installation with an existing ductwork,
simply follow the installation instructions in
this manual to mount the range hood to the
desired location, then connect it to the
ductwork and make sure all connections are
sealed airtight.
Installation Preparation
1. If you need to remove the range, be sure to turn
off the range’s power from the main switch.
Turn off the main gas supply in case it’s a gas
range.
2. Disengage the baffle filter from the hood by
pulling the latch outward and slowly pull the
filter down and away from the hood while still
holding the latch.
3. Remove the bottom cover by carefully
unscrewing the eight (8) screws as shown
below to view the hood’s top screw holes:
4. This range hood comes with 3 adapters: 1
vertical rectangular adapter, 1 vertical round
adapter and 1 horizontal rectangular adapter.
The vertical rectangular adapter is pre-installed
by default. Depends on the type of ductwork in
use, choose and follow one of the instructions
below:
i) Vertical Discharge:
• Vertical Rectangular Ductwork:
There’s no need to change the pre-
installed adapter.
• Vertical Round Ductwork: Follow
the instruction diagram as shown
below to replace the pre-installed
rectangular adapter with the round
adapter.
ii) Horizontal Discharge:
(1) Remove the pre-installed vertical
rectangular adapter and cover the
vent opening with the shutoff plate.
(2) Remove the large shutoff plate on
the back of the hood and the small
shutoff plate inside the back of the
hood.
Loading ...
Loading ...
Loading ...