Loading ...
Loading ...
FORYOURSAFETY
Tools you will need:
Phillips head screwdriver
t 3/8" open end or adjustable wrench
1. Remove the bracket from the prepack
located inside the oven_
2. Decide whether the bracket will be installed
on the right or left side of range location.
3. tf the bracket side of the range is adjacent
to a cabinet, place the bracket against
back wall and cabinet as shown below
ADJACENT CABINET OR FINAL
LOCATION OF RANGE SIDE
PANEL
4_
u
=
7_
3
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) wift be. Place the bracket
with its outside edge at this location and
against back waft. See illustration below.
Determine whether you will anchor the
bracket to the floor or wall Make sure this
location is clear of electrical wiring or
plumbing,
Fasten the bracket securely with the screws
provided, Screws are self-dritling in wood,
plywood, particle and chip board, and
most metal framing If attaching to
masonry, you can buy suitable screws and
anchors at hardware stores,, Use a masonry
drill to drill the required holes.
BRACKET
SCREW MUST ENTER
WOOD OR METAL
WALL
PLATE
/
Using the wrench, back out the four leg
levelers at least two turns. See .your
installation guide for more leveling
information before positioning range_
Slide the range into placeo Be sure rearteg
leveler fully engages the slot in the brackeL If
range cannot be moved back far enough
for rear leg leveler to enter bracket, move
bracket forward as required and attach to
floor in new location
important safety instruction continued
Loading ...
Loading ...
Loading ...