260x180x152mm
AK2803B-V1.1
Place with temperature below -10℃ or over 40℃
Maint e nance
Clean with a soft dry cloth or towel.
Please use neutral detergent, don’t use
organic solvents, acid or alkali toilet clean,
nor cleaning brush, etc.
Otherwise, the surface will be destroyed
or discolored
Don’t use chemical detergent to clean the
sensing area
Clean the air filter every 6 months or when air flow is weaker.
Shut off power (unplug power cord or turn off electric breaker if hard
wired), use the Allen wrench to remove the screws, then take off the
shell.
Carefully remove the air filter, blow out the dust then clean them
with clean water. (Don’t use hot water or chemical detergent)
Carefully remove any dust or objects if found inside the machine.
Internal maintenance
External maintenance
Main machine
Environment saving, no need of paper towels.
Quick dry 10-15 seconds with high speed air flow.
Solid built with stainless steel shell, ease of maintenance.
Overtime protection stops the unit after 45 seconds to avoid overheated.
Energy saving with automatic heating system.
The heating element is off when the room temperature is hot.
Automatically turn on heating element when the room temperature is cold.
Built-in air filters filter 99.97% of bacteria from the moist restroom air.
Insta l lation
According to the installation position, drill
four of mm holes on wall and insert the
plastic screw anchors into the holes.
Aim the holes of the baseplate to the plastic
screw anchors, mount the it on the wall by
4 self tapping screws.
Please avoid the place easy to block peo ple and easy to encounter doors.
If the counter top or obstacles below the machine, the minimum distance should
be 16 inches to avoid reflection to mis-sense.
about 54 inches
Note: AD A requires the bottom of the hand dryer must fall between a height of
38 inches to 48 inches off the floor.
be 4 inches above )
If you don’t use this unit properly or follow the safety guidelines carefully,
it would lead to serious personal injury or property damage
Plug into 120V outlet to
test before installing
Please contact Awoco
customer service for any
issue or replacement parts
at 888-412-3428 or
sales@awoco.com
Ribbed plastic anchor
5x25mm self tapping screw
1350W
AC120V~
Power
Current
12A
Circuit
board
Directly plug the power cord into the 110V
standard outlet. Tie the excess power cord
firmly to the wall.
Drill holes
Remove the shell
8mm
Power
drill
Expansion
anchor
144mm
2
2
2
m
m
Mount the machine
Power plu g
8
Operate
indicator
Motion
sensor
