120cm
108cm
130cm
115cm
140cm
150cm
129cm
160cm
136cm
170cm
143cm
180cm
150cm
122cm
44mm
44mm
1
5
2m
m
280x153x162mm
5
8mm
Pencil
Power
drill
Expansion
anchor
Self tapping
screw
Hook up
Hook
groove
Inlet grille
Safety
screw
Safety screw hole
Φ6mm
Remove the mounting bracket
According to the
installation position,
place the mounting
bracket on wall.
Then draw the positions
of mounting holes in
pencil.
Drilling holes
In accordance with the drawn holes
position, drill four holes 8 mm in
diameter and press the expansion
anchors into four holes location.
Mount the mounting bracket
Direct the installation holes of the
mounting bracket at the expansion
screw anchors and mount them with
self tapping cross screws.
Installing the machine
The mounting bracket has protrudent
hooks formed for inserting into the
slots to hang the machine on it. Press
down the machine until the safety
screw holes on machine and mounting
bracket are aligned.
Tighten the safety screw
Screw safety screw in the bolt
holes to lock the machine on the
mounting plate.
Install the air inlet grille in the
machine and make sure the grille
is locked.
68m/ s
AK2805-V1.1
Place with temperature below - 10℃ or over 40℃
Plug into 120V outlet to
test before installing
Please contact Awoco
customer service for any
issue or replacement parts
at 888-412-3428 or
sales@awoco.com
Mainte nanc e
Clean with a soft dry cloth or towel.
Please use neutral detergent, don’t use
organic solvents, acid or alkali toilet clean,
nor cleaning brush, etc.
Otherwise, the surface will be destroyed
or discolored
Don’t use chemical detergent to clean the
sensing area
External maintenance
Clean the air filter every 6 months or when air flow is weaker.
Shut off power (unplug power cord or turn off electric breaker if hard
wired), at the bottom of the hand dryer, press the click to remove
air inlet grille.
Carefully remove the air filter, blow out the dust then clean them
with clean water. (Don’t use hot water or chemical detergent)
Carefully remove any dust or objects if found inside the machine.
Internal maintenance
Main machine
Environment saving, no need of paper towels.
Quick dry 10-15 seconds with high speed air flow.
Solid built with stainless steel shell, ease of maintenance.
Overtime protection stops the unit after 45 seconds to avoid overheated.
Energy saving with automatic heating system.
The heating element is off when the room temperature is hot.
Automatically turn on heating element when the room temperature is cold.
Built-in air filters filter 99.97% of bacteria from the moist restroom air.
Please avoid the place easy to block people and easy to encounter doors.
If the counter top or obstacles below the machine, the minimum distance should
be 16 inches to avoid reflection to mis-sense.
Note: ADA requires the bottom of the hand dryer must fall between a height of
38 inches to 48 inches off the floor.
be 4 inches above )
about 54 inches
Instal lation
Ribbed plastic anchor
5x25mm self tapping screw
Inlet grille
Safety
screw
Draw the mounting position
Turn the hand dryer upside down,
press the click to remove the air
inlet grille.
Remove the safety screw from the
middle deep hole to release the
mounting bracket on the back
1350W
AC120V~
Power
Current
12A
Upper cover
Core
structure
Power pl ug
Mounting
bracket
Air inlet grille
Bottom cover
Motion sensor
Operate
indicator