Loading ...
Loading ...
Loading ...
16. Press a 1" x 1 1/2" Inner Cap (23) into a Handle
(26). Press a 1" Round Cap (22) into the Handle.
Apply grease to a 3/8" x 2 1/2" Bolt (3). Attach the
Handle (26) to the Press Arm (28) with the Bolt
and a 3/8" Jam Nut (2).
Remove the adhesive backing on a Square
Bumper (9). Apply the Bumper to the Handle in
the indicated location.
Assemble the other Handle (26) to the Press Arm
(28) in the same manner.
17. Find the end of the Short Cable (44) where the
rubber stop is located. Lay the end of the Cable
over a 3 1/2" Pulley (12). Attach the Pulley to the
Frame (80) with a 3/8" x 3 3/4" Bolt (83), a 3/8"
Flat Washer (4), and a 3/8" Jam Nut (2). Note:
Be sure that the Short Cable is between the
Pulley and the lat bar bracket.
18. Lay the Short Cable (44) over a 3 1/2" Pulley
(12). Attach the Pulley and two Pulley Covers (13)
to the Frame (80) with a 3/8" x 4 1/2" Bolt (90)
and a 3/8" Jam Nut (2).
Tighten the 3/8" Jam Nut (2) used in assembly
step 7.
19. Assemble the two 4 1/2" Pulley Covers (87), the
two =1"Plates (86), and the two 4 1/2" Pulleys (85)
with two 3/8" x 1 3/4" Bolts (14) and two 3/8" Jam
Nuts (2).
16
22
17
18
19
3--Grease _J
83 60
Stop
Lat Bar
Bracket
13 12 13
80
2
14
87
86 85
86 87
10
Loading ...
Loading ...
Loading ...