Loading ...
Loading ...
Loading ...
DJI Mavic 3E/3T User Manual
56
©
2022 DJI All Rights Reserved.
Advanced Features
Calibrating the Compass
The compass may need to be calibrated after the remote controller is used in areas with
electromagnetic interference. A warning prompt will appear if the compass of the remote
controller requires calibration. Tap the warning prompt to start calibrating. In other cases,
follow the steps below to calibrate your remote controller.
1. Power on the remote controller and enter the homepage.
2. Select Settings, scroll down, and tap Compass.
3. Follow the on-screen instructions to calibrate the compass.
4. A prompt will be displayed when the calibration is successful.
HDMI Settings
The touchscreen can be shared with a display screen via an HDMI cable.
The resolution can be set in Settings, Display, and then HDMI.
Method 2: Using DJI Pilot 2
1. Power on the aircraft and the remote controller.
2. Run DJI Pilot 2 and tap Link Remote Controller to link. The status LED of the remote
controller blinks blue, and the remote controller beeps.
3. Press and hold the power button of the aircraft for more than four seconds. The aircraft
beeps twice after a short beep, and its battery level LEDs blink in sequence to indicate
it is ready to link. The remote controller will beep twice, and its status LED will turn solid
green to indicate linking is successful.
Make sure the remote controller is within 50 cm of the aircraft during linking.
Loading ...
Loading ...
Loading ...