Loading ...
Loading ...
Loading ...
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench will make assembly easier Standard wrench
sizes are listed.
(1) Pliers
(1) Utility knife
(1) Screwdriver (Small Phillips with a 1/4 inch shank)
(1) Hammer
(1) Tire pressure gauge
(2) 7/16 inch wrenches
(2) 1/2 inch wrench
(1) Tape measure
When right and left hand is mentioned in this manuat, if
means when you are in the operating position (seated behind
the steering wheel)
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
e Open top flaps Remove cardboard from top of wood
crate.
e Remove top frame from carton
e, Carefully remove contents of parts box (see CONTENTS
OF HARDWARE PACK on page 6).
e Cut down allfour corners with a utility knife and carefully lay
down side panels+
e Discard cardboard from alongside tractor
o Remove cardboard from discharge chute
e Remove plastic wrap from seat and hood
TO INSTALL STEERING WHEEL
(See Fig. 1)
e Position front wheels straight forwar&
e Place spacer on steering shaft.
e,
o
Place steering wheel on steering shaft Push
steering wheel down firmly
Align cross holes in steering wheel with holes in
steering shaft, NOTE: Use a small Phillips screw-
driver with a 1/4 inch shaft to align the holes Keep
screwdriver in place as you drive the spring pin in
e From the left side, ddve spring pin (found in parts bag)
through opposite side with a hammer
STEERING
WHEEL
SPRING PIN
SPACER
STEERING
CLUTCH
LEVER
FIG. 1
SHIFT CONTROL
LEVER
BRAKE_;LUTCHPEDAL
VIEW FROMRIGHT SIDE OF TRACTOR
FIG, 2
BEFORE ROLLING TRACTOR OFF SKID
(See Fig. 2)
IMPORTANT: CHECK FOR AND REMOVE STAPLES IN
SKID THAT MAY PUNCTURE TIRES OF TRACTOR BEFORE
ATTEMPTING TO ROLL OFF SKID
• Carefully cut wire ties (front and back) holding tractor to
skid
e Release parking brake by depressing brake-clutch
peda!.
e Place shift contro! lever in NEUTRAL position
e Carefully roll tractor backwards off wood skid
(ASSISTANCE MAY BE REQUIRED )
IMPORTANT: DO NOT LIFT TRACTOR BY HOOD OR
FENDER
Loading ...
Loading ...
Loading ...