Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
TO START ENGINE WiTH A WEAK
BATTERY (See Fig. 38)
CAUTION: Lead-acid batteries generate
explosive gases. Keep sparks, flame and
smoking materials away from batteries.
Always wear eye protection when around
batteries.
If your battery is too weak to start the engine, it should be
recharged If "jumper cables" are used for emergency starting
follow this procedure
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM OTHER VEHICLE
MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED
SYSTEM DO NOT USE YOUR TRACTOR BATTERY TO
START OTHER VEHICLES_
TO ATTACH JUMPER CABLES -
e Push battery boot away from POSITIVE (+) terminal
e Connect RED (+) cable to POSITIVE (+) terminat on
battery, taking care not to short against chassis
e Connect BLACK (-) cable to NEGATIVE (-) terminal on
battery.
TO REMOVE CABLES, REVERSE ORDER -
® BLACK (-) cable from battery.
• RED (+) cable from battery
TO REPLACE FUSE (See Fig. 39)
e Raise hood
e Locate fuse holder under clash
e Remove fuse and replace with a 15 amp automotive-
type plug in fuse (see REPAIR PARTS section for more
information).
TO REPLACE HEADLIGHT BULB
(See Fig. 40)
e Raise heed NOTE: Do not remove plastic headlight lens
when replacing headlight bulb
e Turn headlight harness (holding bulb) 1/4 turn counter-
clockwise and remove
• Pull bulb out (do not unscrew) Push in new bulb
• Replace headlight harness and turn 1/4 turn clockwise to
lock in place,
e Close hood
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly,
stop running, or prevent it from starting
e Check wiring, See electrical wiring diagram in the REPAIR
PARTS section of this manual
DASH
NEGATIVE(-) POSITIVE(+)
TERMINAL TERMINAL
Fig. 38
WIRE HARNESS
FUSE HOLDER
FUEL TANK
FIG. 39
HOOD
HEADLIGHT
LENS
BULB
RUBBER SOOT
HEADLIGHT
HARNESS
Fig° 40
qn
Loading ...
Loading ...
Loading ...