Loading ...
Loading ...
Loading ...
PROCEDURE A
iI
H you are using Me new sleeve (optionally
s,up,p_ied with your unit)_skip to step 3.,
O,lhe_Ti_, install t:he plastic grille lrom #_e kit
Cut the plastic grille to 25o!/2 ``wide and t 5i-
1/4' h_h, Pla_ Me plastic grille to the inside
of the walll sleeve at Me rear flange°
FiG. 4,
B asten the 4 washer _rews to, secure the grille
to the wa!] _ee've. ]'fyou need plastic nuts to,
mount plastic gri_e to, the insi@ d the wal_
sleeve, Mere are plastic nuts in the instal]atbn
kit. The nuts are installed '#o,m the inside of the
slleeve and are pressing into, the _uare holes
of the _ear flanges.
B emove the backing from the Vertical Insu_al:ion
strip, i5%6 x 1ssx is,'s and attach that to the
inside right of the sl_ as shown below.
Remove the backing from the Around Insulation
strip, 67_,,'_x !3_ × 25,,S_ and a'Bach 'thai t:o the
inside front ot the _eeve as _own _ow:
indoor Outd_r
9_/_,° @
F]Go 6
effidenc_/,The plast_ gri_b [_ui_ 'the a_unt of
hot air diverge, thai r_ircul_ thro[sh the unit,
ins_llation
FIG. 7
_ Install the new unit into the wall _eeve.
To, as_mb_e trim, snap the tab of each piece
into the Hot o:1the other pi_e as shown below.
Slide trim over the #ont o1:the air c#nditioner
until trim is flush w_h _eeve as shown _low_
Wall
NG. 8
A CAUTION
• Air _nditio_rs _vered inthis manualp_ an
excessive weight hazard Two or more _0ple are
reeded to move and inst;_l the unit,
To pre_ent iqury or str_n, use proper l_ing and
carrying tech_iq_,es when moving un_,
• W_n handli% the ar conditioner, be carom to
avoid cuts from sharp met_ fins on fronl and rear
coi_s.
• Make sure air condffioner ,does r_otfuji d_ring
removai,
• If unit d_s not operate after insta!!ation c_, to
sure _he circuit inte_upter ha,s not _en trip_d,
Refer to t_ Troubleshooti_ guide for reset
Owtt,er_ Manual 13
Loading ...
Loading ...
Loading ...